What is AirView?¶

AirView allows you to view a presentation output on your own device. This feature is enabled by default. If it’s not working, please check whether AirView is enabled in the firmware configuration.

Open Advanced Settings¶

• Connect your device to the QuattroPod, either via the QuattroPod's SSID or through the same Wi-Fi/LAN infrastructure the QuattroPod is connected to:

• In the address bar of a web browser, enter the IP address of the QuattroPod, either the Direct Link IP or the Infrastructure IP, depending on which your device is connected to. The QuattroPod settings interface will appear:

Log in as Admin¶

• Enter the admin password and click OK to log in. By default, the password is 000000. If this password is not accepted, reset the device using the reset switch.

The following features are available:

The AirView function is available in any modern web browser. Simply connect your device to the same Wi-Fi network as the QuattroPod:

• Note the IP address displayed in the bottom left corner of the home screen.

• Enter the URL ipaddress/?page=AirView in your web browser. For example:

If the Castcode function is enabled, you will need to enter the code here:

You can use the buttons at the top right to start the image display. By default, an image of the presentation is captured every 5 seconds and can optionally be downloaded.

Here is the image output from one participant in fullscreen:

Here is the image output from two participants in split view:

You can then save the AirView web address as a bookmark: